Search results

Create the page "LED Driver and LEDs" on this wiki! See also the search results found.

• S12: Traffic Light Sensing Vehicle
  ...previous laboratory experiments on FreeRTOS operating system, building SPI and I2C drivers, configuring ports, etc. to accomplish the main goal. ...his project are an ARM7 LPC2148 Development Board, ShiftBrite LED modules, and light color sensor ADJD-S311-CR999.
  18 KB (2,791 words) - 17:41, 25 May 2012
• S12: Sound Reader
  ...bass response. Using a 16- channel PWM driver with serial interface each LED is independently controlled to a configurable 12- bit intensity control. *Interface SPI communication between microcontroller and TLC5940
  18 KB (2,836 words) - 19:22, 25 May 2012
• SJ One Board
  * 512K ROM, 64K(96K) RAM, 1M(2M) SPI Flash, and Micro-SD for storage. *: Arm Cortex-M4 variant contains 96K RAM, and 2Mb SPI flash
  20 KB (2,948 words) - 17:58, 7 February 2018
• LPC17xx Software Framework Explained
  #* low_level_init() sets up minimal UART0 Driver and prints out CPU speed #* high_level_init() initializes SPI Flash and SD Card Signals
  3 KB (478 words) - 20:34, 2 August 2013
• F12: Smart Bulb
  ...ipment which has been released to the market incorporates no intelligence, and the functionality is superficial at best. ...presence of occupants, incorporates the diurnal cycle into its decisions, and enables supervisory devices to request changes to the system configuration.
  68 KB (10,476 words) - 20:28, 20 December 2012
• F12: Evil Watchdog
  ...ing a house by roaming around an environment, navigating around obstacles, and sounding an alarm whenever foreign motion is detected. * Waymond Chen: Front motor control and distance sensor programming
  31 KB (4,981 words) - 22:00, 4 February 2013
• S13: Smart Cube
  ...8x8 RGB LED clock allows for the information to be displayed in any color, and dynamic. ...the project, the LPC1758 will take the input from the Front-End interface and output the results on the Back-End interface. Only the current time is take
  44 KB (7,244 words) - 21:07, 23 May 2013
• S18: Rahee
  accessory addresses these issues. To make a bike smarter and to address the issues which making bike-riding safe and bikes secure.
  25 KB (3,859 words) - 10:40, 27 May 2018
• S14: Power Efficient Security Door System for Light-rail using CAN Bus
  ...ncept of CAN bus which is used for communication between sensors, switches and lights of different coaches of the train. == Objectives and Scope ==
  39 KB (6,149 words) - 23:44, 9 December 2014
• Project Advising: Remote Security System
  ...r will be able to use a web or mobile application to view security reports and change settings remotely. ...alerts and a cross-device web application, monthly fees can be eliminated and security can be placed into the property owner's hands.
  33 KB (5,223 words) - 04:30, 20 July 2014
• Embedded System I2C Tutorial
  * The Wiki will remain here for general references about the SJ-One board, and to document student reports. ...capability of sinking that much more current. For example, with a 5v BUS, and 1K pull-up, each device must be able to sink 5mA.
  12 KB (1,979 words) - 20:06, 25 January 2019
• F13: Line Following Robot
  The Line Following Robot detects a black line on a white surface and moves forward following the line. If a black line is not detected, the Lin ...e Dual Serial Motor Controller, two brushed DC motors, twin motor gearbox, and two tires.
  64 KB (10,131 words) - 05:05, 7 December 2013
• F13: LED Display
  A Moderately Fancy LED Display ...f household LED lights (i.e. Christmas lights) via a microcontroller. The LED display will be synced to a song playback.
  18 KB (2,773 words) - 03:07, 2 December 2013
• F13: POV Display
  ...e SJSU board. The microcontroller will interpret the message and drive the LEDs via an SPI interface to display the message on the POV device. ...nted onto the mechanical POV device and the microcontroller will drive the LEDs to produce the message. A website will be setup to provide a user interfac
  17 KB (2,778 words) - 02:04, 8 December 2013
• F13: Remote Control Car
  ...ering). The second board will be mounted on the car and control the servo and motor controller with a front proximity sensor. * Control for steering servo and speed throttle control
  9 KB (1,391 words) - 03:56, 8 December 2013
• F13: Bulb Ramper
  ...60 degrees around and, will trigger the camera shutter in sync with travel and will also have the ability to pan as it travels. 1. Learn about the camera interface and how designs differ in order to protect the circuits inside the camera.
  20 KB (3,315 words) - 02:15, 9 December 2013
• F13: Garage Parking Assistant
  simplify the driver’s task of parking a car in a garage. The parking assistant will automatic assistant will notify the driver of the vehicle's position relative to a predetermined stop point. When the
  28 KB (4,283 words) - 03:54, 8 December 2013
• S14: Power efficient security door system for light-rail using CAN bus
  ...ncept of CAN bus which is used for communication between sensors, switches and lights of different coaches of the train. == Objectives and Scope ==
  39 KB (6,149 words) - 23:38, 9 December 2014
• S14: Virtual Dog
  ...d in many places, for creating many creative toys that will keep your kids and pets occupied, can be integrated with shopping carts, so that you’ll neve ...his is achieved with help of multiple distance sensors mounted on a robot, and a target reference object. Robot continuously monitors the position of targ
  34 KB (5,774 words) - 23:42, 6 August 2014
• S14: Autonomous Control System
  ...rrive at a station. The pods are to navigate the track system autonomously and communicate updates on their location to the master computer. This project **Pods must communicate their location to a master computer and tell the master computer when ready for new route.
  32 KB (5,298 words) - 00:00, 7 August 2014

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)