Difference between revisions of "S15: Touch Navigator"

From Embedded Systems Learning Academy
Jump to: navigation, search
(Design & Implementation)
Line 142: Line 142:
  
 
=== Implementation ===
 
=== Implementation ===
 
  
 
== Testing & Technical Challenges ==
 
== Testing & Technical Challenges ==

Revision as of 00:17, 11 May 2015

Grading Criteria

  • How well is Software & Hardware Design described?
  • How well can this report be used to reproduce this project?
  • Code Quality
  • Overall Report Quality:
    • Software Block Diagrams
    • Hardware Block Diagrams
      Schematic Quality
    • Quality of technical challenges and solutions adopted.

Project Title

Abstract

The purpose of this project is to implement a robot car which will follow the path drawn on the touch screen.

Objectives & Introduction

Show list of your objectives. This section includes the high level details of your project. You can write about the various sensors or peripherals you used to get your project completed.

Team Members & Responsibilities

  • Athavan Kanagasabapathy
  • James Sushanth Anandraj
  • Ravikumar Vanjara
  • Rishit Borad

Schedule

Week Start Date End Date Task Status Actual Completion Date
1 4/7/2015 4/21/2015 Developing Android Application to communicate to SJOne board over UART In Progress In Progress
2 4/14/2015 4/21/2015 Interfacing the motor with the SJOne and controlling the direction and speed. In Progress In Progress
3 4/21/2015 4/28/2015 Writing application in android to draw paths. In Progress In Progress
4 4/29/2015 5/4/2015 Writing the application to control the motor based on the touch input got from android application. In Progress In Progress
5 5/4/2015 5/11/2015 Interfacing with the obstruction sensors. In Progress In Progress
6 5/11/2015 5/18/2015 Integrating the Obstruction detection in main application. In Progress In Progress
7 5/18/2015 5/20/2015 Testing In Progress In Progress

Parts

Parts Cost
1 Dual H-Bridge Motor Driver for DC Motor L293D 2.5$
2 Car chassis parts - Wheels, shaft, DC motors(2), body 12$
3 Batteries 5$
4 IR Leds and IR sensor (TSOP38238) 10$
5 Antennas for Nordic communication 4$

Design & Implementation

The design section can go over your hardware and software design. Organize this section using sub-sections that go over your design and implementation.

Hardware Design

Hardware Interface

Software Design

Implementation

Testing & Technical Challenges

Describe the challenges of your project. What advise would you give yourself or someone else if your project can be started from scratch again? Make a smooth transition to testing section and described what it took to test your project.

Include sub-sections that list out a problem and solution, such as:

My Issue #1

Discuss the issue and resolution.

Conclusion

Conclude your project here. You can recap your testing and problems. You should address the "so what" part here to indicate what you ultimately learnt from this project. How has this project increased your knowledge?

Project Video

Upload a video of your project and post the link here.

Project Source Code

References

Acknowledgement

Any acknowledgement that you may wish to provide can be included here.

References Used

List any references used in project.

Appendix

You can list the references you used.