Development Package

Related Articles

• 2012 SJ One Board
• 2012 SJ One Hello World Sample Project
• 2012 SJ One FreeRTOS Tutorial
• Generate Documentation from Sample Projects
• Eclipse : New Project & Tricks

LPC17xx (SJ One Board) Advanced Topics :

• LPC17xx Software Framework Explained
• LPC17xx Memory Map & Interrupts

Hyperload LPC Bootloader :

• LPC Bootloader
• Hyperload Protocol

Get Development Package

1. The first step to getting started with the Development Package is to get the package itself!

   SourceForge SJSU Development Package

2. Get the Development Package and unzip in your C drive

   It is important to not unzip at your desktop

3. Follow the steps below; screenshots of reference images are included.

Step by Step Tutorial

Here are steps to follow in order to compile program for Embedded Processors:

1. Plug-in your development board    If Windows doesn't install the drivers, browse to your Development Package for the driver	Driver is in Development Package directory
2. Once Board driver is installed, open up Eclipse32_Emb.bat file    Eclipse will start and sample projects will appear on the left side.	Browse Development Folder directory to find bat file
3. Once Eclipse opens, open ONLY ONE project. Close other projects if they are open.    You can right click on one of the sample projects and then choose Open Project	Open Eclipse Project
4. Press Ctrl+B to build your project    Popup window will appear leading to "Build Finished" in the console below.	Build Project
Now it is time to load the compiled program to the Embedded Board 5. Open up Hyperload from the Development Package 6. Your Board appears as a "COM" Port. Open up an available COM Port. 7. In Eclipse, there will be a _Build or Release directory, locate *.hex file      Drag & Drop this file to Hyperload      (or you can click OPEN button in Hyperload to do the same thing)      Press RESET button on your Embedded Board to start Programming.      After Programming completes, close the COM Port in Hyperload	Programming in Hyperload
8. Open up Hercules from your Development Package    Browse to Serial Port Tab, and select 38400bps    Select the same COM Port as you did in Hyperload and click OPEN    Press the RESET button again to see the output of your program.	View Output in Hercules

Troubleshooting & Hints

• Note that you can only open up COM Port in ONE Program

  If you are programming, close COM Port in Hercules and open in Hyperload

  If you wish to look at the output, close COM Port in Hyperload and open in Hercules

• Hyperload will always grab the latest HEX file before programming

  Only change HEX file if you are working on another project.

• Clicking on Set in Hyperload CPU Frequency section will make more choices appear under COM Port speed.

  You can program at any of the baud rates listed