Difference between revisions of "S15: Wireless Power Transfer System"

Revision as of 19:32, 28 April 2015

Grading Criteria

Wireless Power Transfer System

Abstract

This section should be a couple lines to describe what your project does.

Objectives & Introduction

Show list of your objectives. This section includes the high level details of your project. You can write about the various sensors or peripherals you used to get your project completed.

Team Members & Responsibilities

• Team Member 1
  • Haroldo Filho - Lead Software Engineer
• Team Member 2
  • Hemant Raman - Lead Hardware Engineer
• Team Member 3
  • Hassan Naveed - Software Implementation
• Team Member 4
  • Guangyu Chen - Software Implementation

Schedule

 -Light an LED wirelessly
 -Test ADC: read 0~3.3V range
 -Test Nordic wireless: send/receive ADC value

 -Find channel frequency: 7.7MHz
 -Define wireless package structure: status and commands
 -Spec/order motor

 -Implement wireless communication
 -Define software architecture layers
 -Define error code and handler
 -Implement motor control

 -Evaluate ADC reading dynamics and design LPF
 -Implement software architecture layers

 -SW/HW Integration and testing.

Parts List & Cost

Design & Implementation

The design section can go over your hardware and software design. Organize this section using sub-sections that go over your design and implementation.

Hardware Design

Discuss your hardware design here. Show detailed schematics, and the interface here.

Hardware Interface

In this section, you can describe how your hardware communicates, such as which BUSes used. You can discuss your driver implementation here, such that the Software Design section is isolated to talk about high level workings rather than inner working of your project.

Software Design

For the software design, we define a layered architecture where each layer takes its services from the layer directly below it. The integrity of layered system was important as to ensure that no race conditions are generated where two tasks wait indefinitely for each other. The layers are:

1. WIFI 2. Communication 3. Motion Control

Implementation

This section includes implementation, but again, not the details, just the high level. For example, you can list the steps it takes to communicate over a sensor, or the steps needed to write a page of memory onto SPI Flash. You can include sub-sections for each of your component implementation.

Testing & Technical Challenges

Describe the challenges of your project. What advise would you give yourself or someone else if your project can be started from scratch again? Make a smooth transition to testing section and described what it took to test your project.

Include sub-sections that list out a problem and solution, such as:

My Issue #1

Discuss the issue and resolution.

Conclusion

Conclude your project here. You can recap your testing and problems. You should address the "so what" part here to indicate what you ultimately learnt from this project. How has this project increased your knowledge?

Project Video

• Youtube video of hardware prototype

Project Source Code

• Sourceforge Source Code Link

References

Acknowledgement

Any acknowledgement that you may wish to provide can be included here.

References Used

List any references used in project.

Appendix

You can list the references you used.